Prusa XL

Prusa XL Enclosure

Enter the interior dimensions and the drawing redraws itself. Outer dimensions follow from panel thickness, feet and doors.

Saved in this browser
Outer size55.6 × 73.6 × 145.4cm
interior dimensionouter dimensionopenings, lid and glass
opening 39opening 76.3door 92.3front 42.210145.455.6FRONT VIEWwith doors and drawer frontgas strutprinter spacedrawercut-outlid 3041.870904010145.473.6SIDE SECTIONfront at the left, hatched = cut panels40305printer base66drawer55.6145.4BACK VIEWdashed: shelf inside5255.635358.525351070SECTION THROUGH THE FLOOR ABOVE THE DRAWERtop view, back at the top, front at the bottom
TitlePrusa XL printer enclosure
Unitscm
Panellaminate 18 mm
Outer size55.6 × 73.6 × 145.4

Overall dimensions

Outer W × D × H
55.6 × 73.6 × 145.4
Enclosure interior W × D × H
52 × 70 × 90
Drawer space W × D × H
52 × 70 × 40
Carcass height without feet
135.4

Doors, lid, openings

Doors W × H
55 × 92.3
Drawer front W × H
55 × 42.2
Lid W × D
55.6 × 30
Opening in the doors
39 × 76.3
Glass (with overlap)
41 × 78.3
Opening in the back
40 × 30
Cut-out in the floor
35 × 35

Notes

  • The lid comes out at about 2 kg (laminate around 680 kg/m³). Pick the gas strut strength accordingly; two are usual, one per side.
  • The lid rests on the sides, but the doors cover it at the front. A finger notch or a handle on the top face helps when opening.
  • Ball-bearing slides usually take about 12.5 mm on each side, so the drawer body comes out roughly 49.5 cm wide.
  • The ceiling sits on the sides and is screwed from above; the sides stand on a base screwed from below. The sides come out 131.8 × 71.8 cm. The 18 mm laminate back is inserted between the sides, ceiling and base; the doors and front are mounted onto the carcass.
Outer size55.6 × 73.6 × 145.4 cm